Hi I'm new to Punch, and using Version 20.0.3.1018. I can't seem to figure out how to reverse the "saltbox" wall style so that the parallel walls share the same configuration instead of the opposite configuration. I would add an image of the issue but my image will not upload properly. This line of text appears instead:

' Punch Design.jpg (36kb) downloaded 15 time(s).'

Not sure why?

Hi there,

Yes, the image uploaded fine. A little small, but fine.

OK, regarding the saltbox wall: (please follow the explanation with the image attached)

As you need to match the height and pitch of both walls, you must set the properties for one of the walls and reverse the properties for the other wall.

For example, in the image below (I selected the wall that is in front of the image)
1 - The Height A is 96" (pointed with a red arrow) => the wall in the back is reversed and the heights must be equal (pointed with a brown arrow), so, for the back wall the Height C must be 96"
2 - The Height C is 108" (pointed with a green arrow) => the wall in the back is reversed and the heights must be equal (pointed with a yellow arrow), so, for the back wall the Height A must be 108"
3 - The Pitch A is 8:12 (pointed with a magenta arrow) => the wall in the back is reversed and the heights must be equal, so for the back wall the Pitch B must be 8:12"
4 - The Pitch B is 5:12 (pointed with a blue arrow) => the wall in the back is reversed and the heights must be equal, so, for the back wall the Pitch A must be 5:12"

An additional tip: don't forget to press "Enter" after each modification in the properties.



Hope this helps

You're welcome!