Rank: Advanced Member
Joined: 11/1/2002(UTC)
Posts: 7,630
Thanks: 8 times
Was thanked: 141 time(s) in 139 post(s)
|
Hi David Simpson
There are two ways
- Method 1-->Using the 3D workshop
Method two--> In the main program--> Use a piece of floor as counter and use the floor cutout tool (Floor tab) to make the hole. Notice that the thickness and elevation of the floor and of the floor cutout must be the same
Of course, you can edit one of existent cabinets / counters with the help of the 3D workshop
Hope this helps
Patricia |
|
|
|
|
|
|
Rank: Newbie
Joined: 3/6/2007(UTC)
Posts: 0
|
Okay I think I see how it works but why can't I edit an existing sink hole? I don't seem to be able to select the hole in the countertop???
Thank you....
|
|
|
|
|
|
Rank: Advanced Member
Joined: 11/1/2002(UTC)
Posts: 7,630
Thanks: 8 times
Was thanked: 141 time(s) in 139 post(s)
|
David Simpson
Yes, it is possible
In the 3D workshop--> Options--> point selection--> you will be able to select / modify / move each point individually
Hope this helps
Patricia |
|
|
|
|
|
|
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The Punch Software uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
