Rank: Advanced Member
Joined: 11/1/2002(UTC) Posts: 7,632
Thanks: 8 times Was thanked: 141 time(s) in 139 post(s)
|
Hi bob z,
Are you talking about the roofs or the textures? Did you use the Design--> rotate the entire plan tool?
You can always draw any element in Punch in its orthogonal position --> select it--> Edit--> Rotate--> write the desired angle Using the same procedure, you can rotate the roof's pieces
If your problem is with the textures, you must use a rotated texture. This is a problem in MLP because it doesn't have the Material Workshop. To rotate a texture in MLP, you should replace an existent texture
Hope this helps
Patricia |
|
|
|
|
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The Punch Software uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close