Rank: Newbie
Joined: 6/12/2005(UTC) Posts: 0
|
I'm also having the same problem but the Lot Size option does not appear under the Design menu. is there anywhere else it would be??? I am using PUNCH! Master Landscape Pro V8.0.0
|
|
|
|
Rank: Advanced Member
Joined: 11/1/2002(UTC) Posts: 7,631
Thanks: 8 times Was thanked: 141 time(s) in 139 post(s)
|
Hi Kerang Valley Resort,
Check the image attached. is a screenshot of MLP showing where the Lot size option is
Hope this helps
Patricia |
|
|
|
|
Rank: Newbie
Joined: 5/23/2006(UTC) Posts: 0
|
I am having the opposite problem. My lot is only 85' wide, but I can't get the lot size down below 200'. When I print to scale, I get four pages when it would fit on two, with the design right in the middle so it ends up with small bits on all four pages. When I resize in Topo Designer, it tells me the new size is too small and walls/elements will be deleted. Help!
|
|
|
|
Rank: Advanced Member
Joined: 11/1/2002(UTC) Posts: 7,631
Thanks: 8 times Was thanked: 141 time(s) in 139 post(s)
|
Hi mtribe
This happens because you have something (a plant, object, wall, etc) out of the limits of your lot
Try this - Start with the first level, in the first tab (Foundation) and go over the following tabs (Floor, Electrical, etc) - Repeat the process in the second and third floors, with all the tabs , until you find the object
Hope this helps
Patricia |
|
|
|
|
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The Punch Software uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close