Rank: Newbie
Joined: 4/1/2006(UTC)
Posts: 0
|
How do I scale lot to floor plan? We use exact lot azmith in site planner and scaled floor plan in trace. But with both combined house apears out of scale to lot
|
|
|
|
|
|
Rank: Advanced Member
Joined: 11/1/2002(UTC)
Posts: 7,705
Thanks: 9 times
Was thanked: 149 time(s) in 146 post(s)
|
Hi Ruth Holliday
1 - Check if you are using the same units for the lot and house (ft+in? ft? cm?)
2 - Usually, the lot plans show the dims as xxx.xx ft--> check if you used this value as inches instead of ft
If all this is OK, zip and send me your file and I'll check it
Patricia |
|
|
|
|
|
|
Rank: Newbie
Joined: 4/1/2006(UTC)
Posts: 0
|
thanks for the help. It triggered my idea to use virtual ruler on both and matches with know lot lengths with known fp length. I think its to scale. Do you agree?
|
|
|
|
|
|
Rank: Newbie
Joined: 4/1/2006(UTC)
Posts: 0
|
hi again,
How do I positon trace and scanned floorplan toghether on lot?
I use design-move entire plan and rotate entire plan. But trace and lot move together. Scanned floorplan is right where I want it but trace moves with lot.
Thank You,
Eric
|
|
|
|
|
|
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The Punch Software uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
