Hi Mike,

The Autofloor has always a difference of 1/2" regarding the level you are setting

If you have a V10 version, you can correct the floor elevation using fractions of inches--> Go to Design--> Unit of measure--> adjust the precision

If you created the floor using the Autofloor feature, and this is the reason of the 1/2" difference, you can't add handles to the Autofloor

Patricia

Hi Mike

If the floor was not developed with the Autofloor feature, then you have a problem with the floors' elevation

1 - Draw the floor with the Floor tool
Select the floor--> Edit--> Set object elevation--> write the desired elevation

or

2 - Select the floor--> right click on the elevation slider--> write the desired elevation

or

3 - Select the floor--> right click on the piece--> Set elevation--> write the desired elevation

Repeat the process with the second piece of floor so you can be sure they are at the same elevation

Also remember that
--> The ceiling elevation is the bottom face of the ceiling. This means that if the floor of the second floor is @ 108", and your 1st floor has a ceiling of 12", the ceiling elevation will be 96" and the settings of a cutout (if necessary)will be the same: elevation at 96"and thickness= 12"
--> If you used Autofloor in the 1st floor, the ceiling elevation will be the walls' height + the Autofloor thickness

Adding points--> it depends of your Punch program and version--> some of them have the add point feature (a + sign)

Hope this helps

Patricia