Rank: Advanced Member
Joined: 11/1/2002(UTC)
Posts: 7,692
Thanks: 8 times
Was thanked: 148 time(s) in 145 post(s)
|
Hi Michael Lazich,
You can't remove the sides of the cutout area, and even if you can, there will be a gap between the wall and the floor. So you can try these resources:
- If it is only a aesthetic issue, you can "paint" the sides the cutout floor (note the elevation of the yellow man, he must be "inside" of the floor)
- Modify the height / elevation of the garage walls so they will lay on the new floor elevation
- Create a new set of walls, height 24", elevation= -24" so they will cover the sides of the floor
Let us know if you need additional help
Patricia |
|
|
|
|
|
|
Rank: Newbie
Joined: 8/9/2006(UTC)
Posts: 1
|
I've just started using Pro Platinum 10. My plan is a 2 storey and calls for a raised study. Access to the second floor consists of a 5-ft staircase to a landing. The raised study is accessed from, and on the same elevation as, this landing. When I cut out the second floor to provide access for the second staircase (from the landing to the second floor), it works, but I now have a gray "outline" of the floor cutout hanging in mid air in front of the french door to the raised study. Is there any way to eliminate this "border" or outline? If not, is there a workaround?
p.s. I'd gladly send to send you a screen shot, but I'm not sure how to do that at the message centre.
|
|
|
|
|
|
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The Punch Software uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
